If the hand measured length is longer than the machine measured length you will need to add units to the displayed current value, and conversely, if the hand measured length is shorter than the machine measured length you will need to subtract units from the current value setting. To calculate the value to enter, first take a look at the difference in the measured lengths. You are now at the screen that shows you the default calibration numbers factory calibrated as well as the current calibration farvewright for the length measurement. Next, navigate to the recalibration menu by following the directions and flow chart below. If you would like to recalibrate your machine continue reading this document.īefore recalibrating, make sure that you have the latest CarveWright firmware version running on your flash card version 1. At this point you have to decide if the difference in the length measurements warrants recalibrating your machine. Reeplacement display will then ask for the direction the user wishes to measure. Measure and record your board length with as much accuracy as you can get. This is the edge that the board tracking sensor roller will be running on and measuring. Replacing the Z motor pack – CarveWright Support
#Carvewright z axis stall free
It is very important that the board edge that is placed into the machine up against the squaring plate be very clean and free of defects. You will want to consider calibrating the X-axis if you are consistently getting an incorrect board length measurement or if you are replacing the factory sandpaper belts with the rubber belts. There are three calibration settings that can be changed by the user: Calibrating the X-AxisThe most frequently calibrated setting is the X-axis.
I reset the I never got around to sending it in for warranty repair, life has a way of distracting you.
During this carve I received one “Z Axis stall” error message. The very first run I did upon recieving it, you guessed it z axis stall. I just received $ worth of spare parts for my Summer Sign Season. Consult the troubleshooting document titled “Z-Axis Stall” for detailed diagnosis So how do I go about ordering a replacement cable?.
0 kommentar(er)
